纳米果汁充电器安装架

Mount for Nano Juice Charger

2023-06-22 07:26:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This mount/stand was made for the Nano Juice wireless charger pads. I purchased the chargers in a 2-pack from Sam's Club, and wanted a stand to display my phone while it charges at my desk. (for reference I have an iPhone 13 Pro Max and a thick Otterbox case, so it should work with any phone.

Cord management is built into the stand, and a small amount of hot glue or rubber cement is used at the top and bottom of the circle to insert the charging pad.

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
Standard
Infill:
20%
Filament brand:
Sunlu
Filament color:
Grey
Filament material:
PLA
Notes:
Initial bed temperature: 75C, Then it drops to 60C after the initial layer. This helps to avoid warping. The model was printed on a Creality magnetic bed. I plan to do another on a metal PEI sheet. No adhesive or glue is needed.

I Do not reccomend the glass bed on Ender 3 since it only has one heating element, centered under the build plate and bed heating is very uneven with the glass.

Additionally, I use a BL Touch; so the process is to preheat the bed for 75C, run the autolevel then print (assuming you have properly set the Z offset).