瑞蒂威格巨人相关内容

Ritewing Big Drak stuff

2023-06-22 10:52:44

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

These are all parts I designed and currently have printed and installed on one of my Full size (Big) Ritewing Drak's

The nose piece is modular. This setup is designed for an HDZero Micro V2 camera and the HDZero 1 watt Freestyle VTX. THe VTX is mounted on top of the nose for ultimate airflow. The antenna mount sits on top of the VTX and is designed to keep the u.fl - SMA connector as short as possible for low signal loss. You can swap the front nose piece and switch between HDZero and Analog (1.3 or 2.4 ghz for example) in under 5 minutes if you run the wiring for the analog camera during the build process.

My set up uses a Matek F405 Wing (the original 2019 version pre-plandemic) and I run an APD 120F3[x] ESC.

The "Hatch-Latch" part is for securing the equipment and battery bay coroplast covers while still maintaining almost ALL of the room in the equipment bay. Glue (E6000) in place and then glue the nut-certs into the "Hatch-Latch"

The Equip-Hatch-Scoop-r1" part is printed in TPU and the support section you remove from the underside of the scoop works PERFECTLY as a template to trace and then cut the equipment bay coroplast. The scoop has a lip on the bottom and gets glued (E6000) to the bottom of the equipment bay coroplast. Provided EXCELLENT airflow to the FC and ESC.

The GPS mount keeps the GPS in the equipment bay for short wire runs. Glue (E6000) in place. The GPS I am running is the Foxeer M10Q-250.

The Hatch-Cover-Stay-Pair" (PRINTED WITH PETG) is two parts connected to allow for better build plate adhesion which prevents lifting of the corners which I struggled with until I connected them.

The "Front-HatchCover-Stay" can be printed by itself. It has tabs to promote build plate adhesion. It worked fine for me (ALSO PRINTED IN PETG).

Thats about all I can think of. All parts except hatch stays are printed in TPU with 30% infill. The PETG parts are also printed with 30% infill and work perfectly for me.