猫门装饰框架

Cat Door Frame

2023-06-24 12:06:29

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I had a swinging cat door in my basement door that the cat refused to use, so I created this frame instead. It comes in 8 pieces so each one would fit on my 235mm square Ender 3v2 bed.

The hole in the door needs to be about 82x165mm for this frame to fit inside; there's a 35mm trim piece around the whole thing so there is a little bit of wiggle room if it's a bit bigger.

There are four pieces for each the front and back that you assemble like puzzle pieces, and then each set is attached with a 50mm M4 bolt and nut. The holes are specifically designed for these hex socket head cap bolts, which I got in this set from Amazon: https://amzn.to/3NIuxBB

You'll notice from the pictures that those bolts don't actually go through the door, so your door hole just needs to be rectangular. Not that you are probably super worried about more holes in your door at this point, but it does make life a little simpler :)

Anyway I hope you enjoy!

Print Settings

Printer brand:
Creality
Printer:
Ender-3 v2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament brand:
Overture
Filament color:
White
Filament material:
PLA
Notes:
I did print with supports just for the screw holes. Probably not a huge deal either way.

Otherwise should be all straightforward prints.