WPL D12 轮毂支撑器

WPL D12 Wheel Spacer

2023-06-24 17:35:14

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A 1mm tall wheel spacer to fit the standard hubs on the WPL D12 RC Car.

They allow you to push your wheels further out to adjust your wheel fitment closer to the arches (negative wheel offset). They can also remove gaps between printed wheels and the front hub bearings to remove play of the wheel shaft.

As the model is 1mm high, just scale it vertically in your slicer to get your desired spacer width. The bigger the spacer the bigger screw you will need, but a 2mm works with the standard wheels and screws. The spacer in the photos is 2mm high, so 200% scale on the Z axis.

These spacers are designed to have a small enough external diameter to not foul on the outside of the front WPL hub bearing, but if you overtighten your wheels they may flex and lock up the front bearings. Just loosen the wheel bolt slightly if the front wheels don't spin well anymore.

The 3d printed suspension and wheels are by gagdoga_com, find them here: https://www.thingiverse.com/thing:4791644
https://www.thingiverse.com/thing:4776428

Print Settings

Rafts:
Doesn't Matter
Supports:
No
Filament brand:
Any
Filament material:
Anything
Notes:
Use a skirt to prime the filament as these are so small they can fail otherwise. Rafts and brims are not necessary.