复古游戏卡带壁挂存储架

Retro Game Cartridge Wall Mount Storage

2023-06-24 23:48:13

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

These are custom game cartridge racks, designed to mount to a wall (either on a backer board or directly to the wall). The main goal is to enable mass storage of a lot of bare cartridges in an easy to access fashion for actual usage (rather than archival or display).

I've included pre-rendered STLs for a few common sizes of racks, as well as the SCAD scripts to create your own custom sizes. I've printed the 15/16 cart versions on my Anycubic Kobra Max (400mm bed size). The mid-sized (7/8 cart) versions are sized for 200mm beds printers.

This initial posting includes holders for the Atari 2600, NES, Sega Genesis and Sega Master System.

As I complete the designs, I'll be adding holders for the SNES, N64, Atari Jaguar, Intellivision, and other systems as needed.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra Max
Rafts:
No
Supports:
No
Infill:
15%
Notes:
These print without supports. I use a 3mm brim to ensure good bed adhesion, but they all have a large bed contact surface, so that probably isn't necessary. I printed with PLA at .2mm layer height. These are relatively simple shapes, and I was able to print them at maximum speed without worrying about stringing or other artifacts.

How I Designed This

I measured each cart and designed the holders with approximately .25mm clearance on all sides for a relatively snug fit. I designed the holders to be relatively shallow, both to reduce print time / filament cost but also so the cartridges would be fairly easy to remove. Each slot has a "shelf" that extends to prevent sagging and uneven pressure on the cartridge when stored.