JHEMCU RuiBet 1-2S LiPo充电器2507风扇模块

JHEMCU RuiBet 1-2S LiPo Charger 2507 Fan Mod

2023-06-25 17:34:09

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I noticed the JHEMCU RuiBet 1-2S LiPo charger runs a bit warm so I designed this fan mod to provide active cooling. You will need a 5v 2507 fan to create this. Print in PETG or PLA

Instructions:

Remove the bottom plate of the JHEMCU charger. This will be discarded and replaced with "Side A".
Mount 2507 fan on to "Side A" using 4x 10mm M2 screws and secure with 4x M2 nuts
Feed the fan power wires through center hole and solder to 5v/gnd pads on the charger's USB port (you will need to trim away some of the outer USB I/O shielding to make it easier to solder directly to the pads)
Mount "Side A" onto JHEMCU charger base using 6x 5mm M2 screws
Mount "Side B" onto "Side A" using 4x 5mm M2 screws

I opted to use a stepdown regulator and run the fan at 3.3v for a more quiet operation