S&S飞行过山车列车模型（LEGO/K'nex）

S&S air launch coaster train for LEGO/K'nex

2023-07-24 20:19:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a model of an S&S air launch train designed to attach to K’nex roller coaster cars for LEGO riders.

Parts:
For every K’nex roller coaster car you will need 2 car bodies, 4 restraints and 2 axles.

Application:
To use this, remove the coloured top parts of a K’nex coaster car using a screwdriver and attach the new train body onto the black chassis using adhesive, unfortunately this model does not have holes to attach using screws. There should be 2 of these train bodies per K’nex chassis so one over the front wheels and one over the back leaving a gap in the middle for the pivot axle. The bodies are larger than each of the halves of the chassis so will overhang however from experience this should not be an issue. A demo image has been included to show where the models should be attached, note this image does not feature an actual image of this model.

Restraints:
To attach the restraints, place a lap bar at each side of the cylinder infront of the seat and slide an axle into the gap.

I haven’t printed this myself so have listed this model as work in progress as I cannot be certain it will work but I strongly believe it will. The model should be to scale and the restraint has been designed to fit around a LEGO figure securely whilst leaving enough space for most LEGO hairstyles but not all will fit. There should be enough friction in the restraint axle to hold it securely however if it is too loose then you will need to increase the diameter or the axle slightly. As this design originally belongs to S&S Worldwide, I can only give permission for non commercial personal use.

All measurements in centimetres (cm)