安吉卡比克 Kobra Neo ADXL345 加速度计安装支架

Anycubic Kobra Neo ADXL345 Accelerometer Mounts

2023-08-03 17:42:14

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A couple of simple mounts designed to attached the new form factor Adafruit ADXL345 to an Anycubic Kobra Neo for measuring required input shaping (although this may also work with the Kobra Go and other similar printer designs).

No supports are required for the X-Axis mount, just print it in the orientation it is saved.
Use supports for the Y-Axis mount to fill the void on the floating clasp section.

The X-Axis mount attaches to the back of the print head using two existing screws which are holding one of the v-slot wheel, and the front cover of the head (see attached picture). Simply remove these two screws, place the mount and then re-insert and tighten the screws back up.

The Y-Axis mount clamps onto the bed (I clamped it onto the front). Two small M3 screws can then be used if required to add some more pressure and secure it firmly to the bed. Be careful not to damage your bed here, I used a sheet of paper between the screws and the bed and made sure not to overtighten them and it was plenty secure.

Four M2.5 x 6mm screws are used to attach the ADXL345 board onto the mount.