L7型号水槽盖

L7 water plate cover

2023-08-04 17:43:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

As the frame is the same size as the S19 this SHOULD also fit a S19 but I cannot confirm if the holes will be the same for the water pipes, guess it depends on the model, make measurements of your model and the 3D print to see if it fits for you. In the picture you might notice the plate is a tiny bit high at the top and a tiny bit too short at the bottom. I cbf printing it again because I want to keep my miner mining, but I adjusted the 3D print model so it should be the right height. The holes for the water pipe are 12mm

People have suggested to keep the back fans on running low to take any hot air out, I personally did not feel anything hot after 24 hours of run time but better safe than sorry!