Cable Organizer/Holder Collection
Cable Organizer/ Holder Collection
使用说明
- 所有模型资源均由用户上传分享，内容来源于网络公开资源
- 侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
- 模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力
关于费用
我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！
扫码手机访问
抖音私信 @jobsfan
Summary
Heyho
Here you have a collection of Holder to tame your Cable jumble :D I got inspired by different Solutions like peaberry´s Cable Tie Base.
I Printed mine with ASA, 0,2 mm layer Height, 0,6 mm Nozzle, 100% infill, 2-3 Perimeter.
Holder Selection:
Single, I, T, + Holder (3 mm Screw)
Width for the cable tie: 4,8 mm
Pyramid + Screw (S = 3 mm, M = 3,5 mm, L = 4 mm)
Width for the cable:
S = 4,15 mm
M =4,84 mm
L = 5,3 mm
Pyramid + Double Sided Tape (Fast & Cheap print, less strength)
Width for the cable:
S = 3,48 mm
M = 4 mm
L = 5,2 mm
I tested all Pyramid (S) and normal Versions to compare its strength.
No wonder: The screwed ones are far stronger. Only the Pyramid (s) got destroyed during the test with a crowbar :) With all other models or if layed through 2 loops of the pyramid, the holder survived the test and instead the cable ties broke.
The holder got only a small visible deformation after the cable ties broke.
Installation tipps:
a) You can use the holder in different ways. Eather to crowd 4 cable ties into the pyramid or Plus Holder or use 1-2 Cables and increase the strength of the holder this way.
b) You can scale the holder up/ down if you need special sizes.
c) Do not overtighten the screws. I used a torque around 5 Nm and it worked just fine.
Have fun and keep printin! :)
Tags
License
Cable Organizer/ Holder Collection
by MeisterEdel is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
相关内容
猜你喜欢
联系我们
最新模型
-
啤酒盛放器2024-05-08 -
FCX18 1/18比例 RC爬行器 & 无线电站2024-05-08 -
Taco Bell国际象棋套装：车子棋子2024-05-08 -
BabyBuddha哺乳器支撑架2024-05-06 -
Ninja空气炸锅替换手柄2024-05-06
最热下载
-
桌子反面的抽屉2023-03-26 -
Toyota 22RE发动机扩展套件2023-03-26 -
伊瑟宁加德骰子塔（奥斯坦克）2024-01-17 -
浴室排水器2024-04-07
