TapeHolderThin V2

2023-08-05 06:50:46

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I edited the STL for the Tape Holder by dellrio to remove some material (~6g), properly center the pegboard pegs (2" on center spacing between each), and shorten the deck by 0.5" because my massive tape measure is not that deep.

FYI pegs are a hair smaller than 0.25".

Haven't printed yet but will update this when I do to let you know if it was all a mistake.

I also added the Gcode I will use...Cura standard 0.2mm profile for Ender 3 but with:

20% cubic infill, tree supports for the pegs, and localized 100% infill above, below, slightly to the sides, and inside the pegs for strength.

EDIT: Print turned out beautiful... Seems nice and strong. Used a slightly different gcode than what is posted but will leave it up in case anyone else wants it