智能空气质量监测装置外壳

Outdoor Air Quality Sensor Housing

2023-08-05 23:36:57

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an Outdoor Case for a 9 x 15 cm prototype PCB / Sourcing Map with sensors.
I use it for an Air Quality Sensor Project to monitor a few values on the balcony.

I notice that the distances to the holes at the corners of the available boards are different depending on the model. Therefore, there is a square contact surface. If necessary, glue it down.
There is still a gap in the wall on the long sides of the floor. These are used for the USB connections that extend beyond the PCB.
Moreover, there are two holes in the roof of the housing for the cables of the 10.5 x 6.5 cm solar panels mounted on it. I added some mm to be sure to have enough space on the printed object to insert the panels.
In addition, there are holes on the side, which I use to tie the housing to a railing with cable ties.

There is more space as i needed. But i want to have space for more sensors i will add in future.
Perhaps it is generally suitable for use as a weather station or with corresponding sensors.

It is my first self-created 3D model. So it's not perfect. For example, the orientation must still be set so that the roof lies flat on the print bed. But this can easily be done in the slicer.
I will probably make some changes to the model to improve it. Depending on how much it's good for.

But maybe it's a useful object for someone else too.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra Go
Filament brand:
Geeetech
Filament material:
PLA
Notes:
My Print Settings on Cura 5.4.0:

For all Parts:
- Walls: 4
- Infill 20 %
- Infill Pattern: Triangles
- Please reconsider the support settings. I have problems getting this out of the vents.
Housing Roof:
- Support: Normal, Everywhere, Grid, 50 % Density
- Build Plate Adhesion Type: Skirt
  -> otherwise my printer extrudes too little filament at the starting point.
Housing Wall:
- Turn the model upside down!
  => Then the openings of the ventilation slots are up and it is easier for the printer.
- Support: Normal, Pattern: Grid, Density: 15 %
- Build Plate Adhesion Type: Raft (Maybe not necessary ...) 7 mm
Housing Bottom:
- Build Plate Adhesion Type: Skirt