床垫保温夹持框架 6毫米偏移

Bed insulation holder frame 6mm offset

2023-08-07 00:44:13

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I made frame offset so as not to create unnecessary tension on the frame and on the table's springs. My insulation is 7mm thick, but the frame has a 6mm offset to lightly press down on the insulation.

Changes from the original project:

6mm frame offset from the bed (be careful if you want screw frame to bed, you may bend bed, I removed this nuts after all)
Pins going into the second part of the frame. They are not perfect and may need some sanding or use Hole Horizontal Expansion options.
Instead of holes for the clamp, I made a hole for the M3x30mm screw

Print Settings

Printer brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament brand:
Devil Design
Filament color:
Black
Filament material:
ABS+
Notes:
No supports in cura but I enabled expirimental options:
- Enable Bridge Settings
- Make Overhang printable
I used ABS because I assumed that in the middle the frame might need stretching to connect the two parts