Insteon 开关箱盖替换套件

replacement enclosure for Insteon on/off

2023-08-08 06:56:55

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

My Insteon 2635 on/off module was several years old. It was installed in my garage which is without temperature control. I grabbed it to pull it out of its socket, and its enclosure shattered in my hand. This project is a replacement enclosure. It happens to fit the shattered remains of my Insteon module. It probably won't fit yours without some customization.

PLA is NOT recommended because it softens at lower temperatures.

I used PETG. The odd colors in the photo are because I used scrap ends of filament spools.

From the broken original enclosure, harvest these parts:

the LED lens. It is very small. Use a small blade screw driver to push it from the outside of the old enclosure and it should pop loose.
The four flat head screws that hold the old closure to the old shell.
The two round head screws that hold the existing spacer to the PCB.

Installing the lens in the printed shell was a bit tricky, mostly because the lens is so small. I used a hobby knife to scrape all the edges of the lens hole, which was required to get it to slide in. I did not need to glue it in place as friction holds it well enough.