库兹小港

Koozie Cove

2023-08-19 01:07:50

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Are your kitchen drawers always clogging up with those stupid can koozies?
Are you lost in confusion because you like cold beverages, but the koozies are always taking up too much space in your kitchen drawers?
The Koozie Cove is here to clean up your life and that messy drawer!
Comfortably holds 5-7 koozies.

Print the STL file twice, and use small rods of standard 1.75mm PLA to index and glue/hold in place.
I recommend aligning the top and bottom shells opposite-- so that the large openings point in opposite directions.

If you're ok with a little bit of sagging on the outer non-koozie surfaces, you should only need supports in one spot (see screenshots). However, for a perfect print you may actually need supports all the way around, because the shells have strongly rounded edges.

You may need to tweak the line/wall/perimeter width to ensure at least one layer surrounds the indexing (female) holes. Make sure you check your GCODE visually for walls around these holes (see screenshots), because these walls are very thin. If your line width is too large, it may create gaps near the indexing holes.