侧边载具

Side Carrier for 5 Gallon Bucket - Ver. 4

2023-08-23 11:24:20

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This was something I made for a beach cleanup non-profit, Essence of Earth LLC. They had been manually separating cigarette butts from trash. They count and send them to a special recycling center that specializes in cigarette butts.

This is the fourth and final version I made for them. The team had only one more request, and that was if they could be made stackable. Everything else was perfect.

So for this final version I removed the holes for the reinforcements. This made all the walls thinner. I also changed the general1 shape into a bit more of a square to maximize the container carrying capacity but not increasing the overall dimensions. I added holes in the bottom of the bucket because the cleanup crew will often rinse these out after cleanups and if they stack them then holes will help with drying. I added some extra bends in the long arm that holds onto the bucket to add some rigidity and strength. Finally, all the vertical walls were drafted at least 3 degrees. This gave it the ability to stack within one another and allow the crew to store multiples of these in a much smaller area.

The piece is meant to be printed without support and should be printed with the bottom of the bucket pointing downwards. This is all based on my Ender 3 Pro.

I have continued to place the non-profit organization's name on the top of the bucket (Essence of Earth).