螺丝刀工具，内置存储

Ratcheting Screwdriver Tool, With Built In Storage

2023-08-24 00:43:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Work in progress ratcheting screwdriver remixed from Cheff4K's Screwdriver Tool.

If printed properly, this should be able to handle quite a bit of abuse, didn't test the maximum torque of it but considering its body diameter and the force I used to test it, its quite strong

IT REQUIERES A 608(skate / spinner) BEARING

PRINTING SETTINGS FOR STRENGTH:

(I printed with this settings, but lower should be a bit better)

PLA Parts:
200° Nozzle
60° Bed
0.3mm Layer height
0.6mm Nozzle

PETG Parts:
250° Nozzle (even though filament recommends max of 235°, this is mainly for layer adhesion)
80° Bed
0.1mm Layer Height
0.2mm Nozzle

Low layer height is not needed, but the 0.2mm Nozzle is, since it makes sharper edges, which are needed for the ratcheting mechanism. If you can somehow get away with 0.2mm nozzle and 0.2mm layer height, go for it and post your results

Print Settings

Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.1 and 0.3
Infill:
35% is good enough
Filament brand:
A good one
Filament color:
Black and white
Filament material:
PLA and PETG for ratchet
Notes:
For printing the Inner Ratchet part, make sure to do so in PETG filament, <=0.1mm layer height, with a 0.2mm nozzle, 250° or higher nozzle temp and 10-30% fan speed to ensure maximum layer adhesion

Post-Printing

Fitting

Fitting the tip into the ratcheting body of the screwdriver may requiere a bit of heat on the corners and pushing with fingers outside, just to remove any elephant's foot