DDR Gen1 阶角支架填充/衔接件 - 面板振动减少器

ddr gen1 stage corner bracket filler/spacer - panel wiggle reducer

2023-08-24 17:33:31

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

this remix made the filler fit better in gen1 ddr arcade stages
biggest change was making it extend out a little to almost completely eliminate panel wiggle
I made this for my routed panels but it should be fine either way

your results may vary as there will be small inconsistencies with the metal switch frames

install top piece, use a screwdriver to help press it in
slide bottom piece in all the way to keep panel from hitting it

no special instructions, pla is fine, .2mm or thicker layer height is good, low infill %

side note for anyone routing panels, a small metal file can be helpful for quickly making fine adjustments to areas you cut as well as smoothing them out
one issue I had was the cut not being deep (as in panel thickness) enough, and the table mounted dremel with router attachment I was using somehow didn't make it easy to level out, so filing down the ends of the cut was an easy solution to that