Nissan Leaf ZE1磁感应式充电器盖

Nissan Leaf ZE1 MagSafe Charger Cover

2023-08-25 19:45:55

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Needed somewhere to put a MagSafe charger in my Leaf, so decided to use the storage space in the middle of the centre console.
The contours of the print are such that I can put my 13 Pro Max in Apple clear case 'camera first' and the phone lays flat.

I printed in TPU and haven't tested this with solid filament.

Fitting instructions:

Remove 'gearstick' trim (it pulls up)
Remove the OEM rubber matt (its held in place by the trim piece you just removed)
Position your charger and this print and stick the charger down. I used VHB tape. I didn't stick this print down as it was a snug fit for me.
Do some wiring. I used an 'add-a-fuse' adaptor in the fusebox on the passenger side of the cabin and ran a cable behind the glovebox to a 12v/cig lighter extension. Not sure if this is on the drivers side for LHD models?
Route the cable
Put the car back together.