透视竹制X1C垃圾桶

See Through Bambu X1C Waste Bins

2023-08-26 02:43:34

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Another Bambu Labs X1C Waste Bin. This one however has a see through window allowing you to see if it needs to be emptied at a glance. There are two sizes included here, a smaller one for space saving and those of you who don't run a lot of filament swaps, and an XL which will give you considerably more space and should handle most prints.

The see through window works by sliding through 3 microscope slides https://amzn.to/44Qmed7 (the ones I used) into the slot on the bin. You can alternatively take a 2L plastic bottle and cut an appropriate window, but the glass looks amazing.

Print Settings

Notes:
I printed these without supports, just orient them so they don't need supports. The bin prints straight up. Just be sure you have bridging options enabled for the couple of gaps that it has to bridge. Prints in a few hours on an bambu. NOTE: If you do use a bambu to print these you must increase your build volume to 252mm. The bin uses more than the stock 250mm bed volume. Bambu allows you to use up to 256 of Z but the slicer is set to 250. There is a screen shot of the settings attached here. otherwise, straightforward print. Go crazy on speed :)

Custom Section

Slide in the 3 slides https://amzn.to/44Qmed7 or whatever brand you buy. I have no affiliation to this brand, just what I used. Use a cut up plastic bottle if you prefer not to buy the glass slides. The magnets you need to attach the top are 6x3mm magnets https://amzn.to/3Kqwm3U are ones I used. Just press fit those into the holes on the lid. You're ready to go!