2000-2007年Mitsubishi Lancer 2.0L冷气进口套件（非Evo版）

2000-2007 Mitsubishi Lancer 2.0L Cold Air Intake (Non-Evo)

2023-08-27 00:56:24

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

2000-2007年Mitsubishi Lancer 2.0L冷气进口套件（非Evo版）

Summary

YOU MUST PRINT WITH PETG OR SOMETHING THAT CAN HANDLE HEAT AS WELL OR BETTER THAN PETG!!!!!!!!!!!!!!

The battery must be moved to the trunk to make room for the pipe to go down into the bumper on this particular car. I also had to use a grinder to make the hole big enough, but that was most likely only specific to this vehicle. I only cut into non-structural sheet metal. It is easy to figure out where to cut once you have the headlight off.

You will need to buy two 3" rubber couplers and a cone filter with a 3" opening.

You will also need to buy 4 bolts & locking nuts, and a piece of flat aluminum bar from Home Depot or Lowes to create the metal support piece that connects to the MAF adapter down to the old air filter box mount.

The printed coupler will be JB Welded on to the straight side of the turn piece and the short straight piece.

The short straight piece goes down into the bumper and the cone filter is mounted to it.

The long straight piece is the one that connects to the MAF adapter on one side and the turn piece on the other side.

This intake might fit other vehicles but I have only tested it for the 2000-2007 Mitsubishi Lancer 2.0 (Non-Evo).