LC Racing LC10B5风扇固定架

LC Racing LC10B5 Fan Mount

2023-09-06 19:22:05

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I couldn't find a suitable fan mount for the LC Racing LC10B5 so I designed this fan mount to hold a 30 mm fan along the same axis as the motor. The nylon lock nut sticking up from the chassis made this a little tricky, but this solution works fine. It can support a 30 mm fan up to a thickness of 11 mm. I can still remove the lock nut that sits in front of the fan with my socket driver. I have gone through 2 full batteries testing this fan and the mount. With no other changes to the car my motor temp went from 180 deg C with no fan down to 120 deg C with a single 30 mm fan installed. The mount helf up completely fine.

I made this out of PLA+ which I think is a better choice than regular PLA as it is stronger and has better heat resistance.

To install, you will need to remove the centre diff to get the rear centre drive shaft out of the way. Remove the M3x10 mm screw where the fan is to be installed and secure the fan and mount using an M3x12 mm screw instead. I found an M3x12 screw in the spares bag that came with the car.

Print Settings

Printer:
Tenlog TL-D3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
20%
Filament brand:
Fashion 3D
Filament color:
any
Filament material:
PLA+
Notes:
20% infill seemed fine, although higher infill can only make it stronger.

When printing, I rotated the item 90 deg around the Z-axis so that the mount is aligned along the Y-axis of the print bed. This is so that when the print bed moves back and forth the skinny parts do not wobble. The wobble could result in a bent print.