高架养护平台轻微斜坡台阶（22.5度角）

Thrive Turtle Elevated Basking Loft Gentle Slope Ramp (22.5 Degree Angle)

2023-09-06 19:23:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I added repitle turf to my Thrive Turtle Elevated Basking Loft ramp, but even with the extra grip, the sharp 45° angle was too much for my red eared slider. This new ramp is at a much gentler 22.5° angle. It has openings for easy grip and to also allow waterflow.

The overall length is 265mm since that was the maximum printing width for my Ender-6. The ramp will reach down about ~4.10", so you may need to raise your water level to accomodate.

Updates

• 2023.09.28: Added a TPU edge guard for the ramp corner.

Installation Notes

• Glue the ramp to the top bezel. There's a recess in the bezel that the sides of the ramp will line up with.

• Pop out the 8 clips holding the existing ramp frame in place.

• Install the new ramp assembly and bottom bezel, then secure them together with the original clips.

• If your turtle keeps ramming into the corner of the ramp by the glass, you can slide the edge guard over it to protect their shell. If you want to add a guard on the other side, simply mirror the part in your slicer.