Spiralized Test Tubes

2024-01-08 12:38:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This model is part of a set of five different sizes of test tubes: https://than.gs/m/988494

These “Test Tubes” can be used as flower holders, seedling holders or as a toy chemistry set!
See here for video: https://youtu.be/Yl8F2EzHjo4
The models feature a special design feature that allows them to print in spiralized mode to optimize optical clarity. With careful printing and a bit of post-processing these test tubes can hold water!

Download includes five standard test tube sizes: 6ml (75x12mm), 10ml (100x13mm), 19ml (125x16mm), 36ml (150x20mm), and 55ml (150x25mm).

If you were to print a standard test tube shape in spiralized printing, the curvature on the bottom would result in poor layer adhesion, resulting in a weaker print that would not hold water.
If you look closely at these models, you will notice that there are a series of slits in the rim and curved bottom. When sliced in “spiralized mode,” these slits create a toolpath that traces back and forth over itself creating a stronger and more watertight surface than you would get otherwise.

There are 3 versions of each size. These different versions optimize the toolpath for different nozzle sizes. If you are not getting a good print with one, try a different one.

Print the files in spiralized mode as oriented with the bottom up. Set your “Bottom Layers” to zero and avoid using brim.

The small sizes are more likely to be watertight right off the build plate. In my testing, about 50% of the larger sizes are watertight right off the build plate. There are a few things you can do to make your test tubes watertight.

Decreasing layer height, raising the nozzle temp and increasing the flow rate a bit will result in better layer adhesion with fewer gaps.
The best and most reliable way to ensure watertightness is to apply a thin layer of gap-filling CA glue to the bottom of your finished prints. A well printed and sealed test tube will hold water indefinitely.

Compatible Test Tube Racks are available here:
Modular Wire Racks: https://than.gs/m/988496