PowerMac G3（及早期G4图灰色）PC转换套件

Powermac G3 (and early G4 graphite) PC conversion kit

2024-01-09 01:04:12

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a Powermac G3 (and early G4 graphite) PC conversion kit.
It will make your Powermac case accomodate mATX pc components.

Attention: NOT all motherboards will fit due to the optical drive plate. If necessary, this must be removed.
Intel® Desktop Board DH77EB does fit.

A power button solution must be found individually.
There's many and various creative ways to solve this.

Remove the following:
1) Original motherboard.
2) Internal locking mechanism large plastic plate.
3) Motherboard standoffs (rock them from side to side with a pair of pliers until they disconnect, then push them down and out of their holes).
4) Original PSU.
5) Original IO Cover.
6) All cables and connectors.
7) Double sided tape under motherboard's original location.

Assembly:
1) Outside of the case - screw the new motherboard to the mATX mounting holes adapter.
2) Connect a card to the motherboard.
3) Inside the case - place in the correct location using the card as location guidance.
4) Draw a line to the side of the mounting holes plate.
5) Disassemble everything.
6) Glue the mounting hole part to the sheet metal using the line you drew (Gorrila glue is recommended).
7) Connect the new IO shield.
8) Assemble the new PSU.
9) Route PSU cables.
10) Connect motherboard.