螺丝和螺母显卡展示架

Nuts and Bolts GPU Stand

2024-01-09 08:21:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Step 1: Print the base and 2 nuts and bolts. I recommend printing with support (for under the pci slot). Try to press fit the bolts into the hex holes in locations that will best support your GPU. If you can't get it, try to keep it aligned as best you can for the next step.

Step 2: Once you get it started, use a long 10mm socket over the shaft of the bolt, and use many light taps to send the head of the bolt down into the hex hole (on a flat surface like a hardwood floor).

Step 3: Screw the nuts onto the shafts of the bolts that you have press fit into place. Put your GPU on top, and use the nuts to adjust the height, so that the GPU balances and doesn't fall over. Also try to go high enough so that the card isn't bottoming out in the pci slot.

NOTES:

I would not recommend using a hole that doesn't have all 6 sides to fit the bolts (i.e. the edges of the base), but if you give it a shot let me know if it works.

I suppose you could print additional nuts and bolts if you wanted more to fit in the stand, but I don't know how much pressure the base can take. The bolts press fit in there pretty tight, so keep that in mind.

I had to print with the model at a 45 degree angle as seen in the very last photo to be in bounds on the plate for my Bambu P1S.

I need to include attribution for this as a source as well, I used it for the nuts and bolts. I can't figure out how to add more than one source, but I will keep trying: https://www.printables.com/model/424895-gpu-support/files