银色铅笔盒小型款式

altoids tin bit case

2023-03-26 17:47:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

If you don't have a 3D printer, I sell this design along with the tin at: https://www.etsy.com/listing/1377181851/ltt-lttstore-screwdriver-bit-case

This is an insert for an Altoids tin, for storing the lttstore.com screwdriver bits. It will not fit standard bits! An Altoids tin is too short for standard 1/4" bits.

It can fit the entire set of bits, 6 sets of 12 bits, 72 in total. No special filament is needed, an Altoids tin is barely sized right for this task, so TPU or any other fancy filament doesn't matter. PLA is fine.

Note, standard ¼" screwdriver bits are too tall for an Altoids tin, they will not work. This is only for the special 20mm lttstore.com bits. If you are looking for a good set of standard bits, I recommend Wera or Wiha. Also, you will need to store the magnetic bit upside down so it doesn't come out when you open the lid, which usually results in bringing along another bit with it.

You may have to wiggle a bit around in its hole a little bit on the edges and in the corners, due to the very slight shrink when the part cools, it makes those bit spots every so slightly hard to remove bits from. What I do is, take a bit and put it in the corner spot, then tip the bit around in a circle to loosen it up a bit. The center spots don't need this since they don't have the cooling issue.

银色铅笔盒小型款式

朋友，你觉得上面这个模型，属于下面的哪个分类？