日立示波器（V355及其他型号）中等尺寸旋钮更换

Hitachi Oscilloscope (V355 and others) Medium knob replacement

2024-01-14 03:48:46

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a functional replacement for the knobs on a 1980s Hitachi Oscilloscope. I printed these for a V-355 but it should fit others from the era. These are the knobs on the end of the voltage selector, but are also used elsewhere on the scope.

These knobs have a tendency to crack or be missing.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.1mm
Infill:
100%
Filament brand:
any
Filament color:
any (red and black are accurate to most scopes.)
Filament material:
PLA / any
Notes:
Printer was actually a V3 KE but that's not yet a selectable option.

For best results, try to get the seam to align with the selection detent. I did this by manually setting the seam to x = 5mm, y = -5mm on the model.

The part was small enough and printed slow enough where I didn't need a raft on my PLI print bed, but you may need to experiment with this.

Since slicers vary, you might need to scale this up or down a couple percentage points to get the center knob to properly fit. This friction fit pretty well as-is with default settings (aside from those mentioned) in the Creality slicer, but with something this small and precise YMMV.