机器人眼睛 - 独立控制

Robotic Eyes - independently controller

2024-01-14 10:58:02

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I designed this to all snap together easily. each eye and eye lid uses its own servo and is able to be independently controller. GH-S37D Servos snap right into the base. The eyelids and eyeballs have attached servo horns. Screws are not required, but will give you a more dependable setup. I use a Raspberry Pi 4B to control everything, but you could use most any Raspberry pi or Arduino. I have only printed this using PLA+, but most filament types would likely work. I do not have any good footage of how to put this together, but it is really simple and all snaps together. See my tiktok for actual footage of the unit assembled until I am able to get more instructions available. https://www.tiktok.com/@3dprintingrobotics?is_from_webapp=1&sender_device=pc