Sabrent 16端口USB集线器支架

Sabrent 16-port USB Hub Mount

2024-02-04 13:06:26

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Wall mount for a Sabrent 16-port USB hub. Designed to use short door hinge screws but anything with a roughly shaped head will work. In my case I was mounting to a 3/4" sheet of plywood clamped to a free-standing shelf. There are two pieces with the bottom having a cutout for the cords and holes to fit a standard phillips bit in to get to the screws and the top just requiring a little finesse to angle the bit/screw. You will need to remove the rubber feet from the hub.

Best to mount the bottom piece level, insert the hub, then add the top piece and outline where it goes. Remove everything and mount the top piece. Slide the hub through the top and press every button on the way down to get past them.

This 1st version works but needs improvement. I designed dimensions with a hair of wiggle room though it becomes not enough unless you get a countersink bit and really open up the screw holes enough so that your screw-head can sit flush on the inside. As it is I was just barely able to get the hub slid through with a lot of wiggling.