3D模型：Eleaf iStick TC40w 扩展壳（原装面板）

Eleaf iStick TC40w Extended Shell (Original faceplate)

2024-02-04 18:45:06

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I needed to replace the battery, but a 18650 wouldn't fit in the original case. I found Matthamatic's extended case, which worked like a charm, but i wanted to use the original front plate.

The front plate is just glued to the metal housing on the original istick so you can peal it off easily. I would recommend you to start from the bottom and use some tweezers, and approach it as flat as you can, and also try to use as much surface of the tweezer as you can. When i started from the top, it broke the edges of the plate around the fire button.
If you can manage to bring the glue as well it's also better because you don't have to glue it on, you can just use the original glue.

I also extended the case a tad more bit.

To make the bottom part and a top part flush with the shell, you heve to cut out a tiny bit from the two "cylinder", where your screw goes in. For the easier print i didn't modified that. For this you can use a small side cutters.

Be cautious when working with lithium batteries, use this at your own responsibility!

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
Doesn't Matter
Resolution:
0.28 - 0.2
Infill:
Doesn't Matter
Notes:
Print upside down so it wont be any bridging.
I used PLA, but if you want a bit more stronger outcome you can use PETG or ABS