水冷Peltier云腔模型

Watercooled Peltier-Cloudchamber

2024-02-04 20:25:16

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I built myself a watercooled Peltier-based Cloud chamber, because I had an AIO Watercooler for a PC laying around.
In my case it is an Enermax III Liqmax RGB with a 240mm Radiator. The radiator is screwed in with 2x M3.5 screws along the support beams, it holds up very well and does not shake or anything.
Obviously you will need some stuff from the hardware store, in my case a M4 threaded rod that I cut to the right length, corresponding washers and nuts. The hole pattern I used to correctly align the 3D-printed parts with the waterblock was the AM4 standard.

The soldered "electronic" part is all internal in the space under the pump-block. I used pin-strips to connect the fans and pump to 12V (as I did not want to cut the cables of the AIO. This also would enable me to use it again in a PC build if I ever wanted.).
Main power for the Peltiers (3 stacked, a "TEC-12709" that is getting 12V, and 2x "TEC-12706" that are recieving 5V and 3.3V) comes from 3x4mm Banana-Sockets and leaves through one common ground.
All in all the systen consumes ~100W and reaches a temperature of about -25C at the cold plate. The radiator is of course way overkill so it does not even get warm.

I hope this inspires someone to build it for themselves, it was a really cool and fun project and works well! In the Photo you can see an Alpha particle as well as some Beta particles
Any questions? Leave a comment!