手机支架

Phone Tripod

2024-02-05 23:58:45

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a remix of LoboCNC's (Zoom Phone Tripod (Improved) https://www.printables.com/model/176119-zoom-phone-tripod-improved). The original base, due to its thin perimeter walls, tended to crack once the legs where clipped in place. On top of this, the legs would sometimes pop out during use as they were only held in place with tension. To fix this, I thickened the base's perimeter wall and added a retaining slot, pin, and block.

P.s. I also added a set of legs with greater clearance (.1mm radius or .2mm diameter) which have very little tension when installed and no bending slot.

Edit: Note also, DrLex's notched version (https://www.thingiverse.com/thing:4538021). Would be a great feature to add.

ASSEMBLY
A dab of CA glue is added inside the leg's pin holder and then inserted into the base as normal. The legs are then rotated to 30 degrees so the pin can be inserted from below and glued into the leg's pin holder. The block is added to cover the hole and sanded down to be flush with the base.

Print Settings

Printer brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
.12
Infill:
20
Filament brand:
Creality HP
Filament color:
Black
Filament material:
PLA
Notes:
Recommended to print the base with thicker walls or 100% infill to increase perimeter strength.