苹果视觉 - '双摄独立配置'带状适配器/夹子 - V1

Apple Vision - "Dual Solo" band adapter/clip - V1

2024-02-06 02:37:39

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

These clips allow you to attached a second Apple Solo Knit band for the top of your head. It makes wearing the Apple Vision Pro dramatically more comfortable, and adjusting the bands is a breeze with the knob!

You are solely responsible for any damage you may cause to your band. Make sure your print is clean, otherwise you may scratch the silicon band near the earphones.

Due to the nature of the small clip attachment, you need to print this in high resolution, 0.10mm recommended for best results.
To install, remove the current band from your Apple Vision Pro. Slide one clip on each side, until it stops. Do NOT force into place.
Clip the back-of-head solo band back into place.
Now clip the top-of-head solo band onto the clips, they should clip into place.

DO NOT Carry your Apple Vision Pro from the top band! Always use two hands to carry.
Your print quality will vary depending on your printer.
I recommend a small size solo knit band for the top. If you find that you're unable to fully tighten it, it's likely that the top band is sitting too far forward. Loosen it, then move it back toward the top of your head.