TPU三聚甲基丙烯酮电池箱，1300mAh CNHL锂电池

TPU Battery Case for 1300mAh CNHL Lipo

2024-03-13 13:59:00

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I've been tinkering with a race quad lately, and I quickly realized how much abuse that a bottom mounted lipo battery must endure.
Even just a tumble through the weeds has left scrapes, cuts and dings on my 6s lipo batteries. It's just a matter of time before a puncture happens and the fire is let out.

I designed this simple case, built specifically for the 1300mAh CNHL lipo to hopefully negate any harmful battery damage due to collisions or tumbles when crashing.
It also doubles as landing feet to stabilize the quad during take off and landing.

You will need a spare grippy battery mat that's 30mm (or less) wide to effectively use this holder. The TPU alone isn't grippy enough to keep the battery snug.
There is a 30mm wide recessed channel cut into the top side of the case for an adhesive battery mat to be attached.

If the fit seems too tight for your battery, don't continue forcing the battery into the case it may become jammed in there and very difficult to remove. There is a relief hole cut in the opposite end of the case to gently push the battery back out (never pull on the leads), but this should not be an issue. Check your print settings/calibration and re-print.