Dishwasher control panel

Dishwasher knob

2024-03-14 01:22:21

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

After the control knob of my Beko dishwasher broke in my fingers, I made this non genuine replacement part for the DFN05X10S dishwasher.
Fits and works well, but read the post printing info for a tip with it.

Print Settings

Printer brand:
Flsun
Printer:
Flsun Super Racer
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2mm
Infill:
10% Gyroid
Filament brand:
CC3D
Filament color:
Deep Cyan
Filament material:
PLA
Notes:
I printed with supports as it was my default profile, but don't think they are necessary as they are only in the finger grips cut-outs which are quite small.
Printed with three walls to add strength to the sleeve making it less likely to break with the rotation applied in normal use.

Post-Printing

After printing, before fitting

To get this to fit I intentionally made it to be a tight fit. It is actually that tight a fit that to make it go on, boil a kettle and run some boiling water onto the sleeve where it slides over the switch cam, turny bit.
Make sure you don't burn/scald yourself as I did this pour over, wait a few seconds, tip the water out three times to soften the sleeve a little. After this it pushed on fairly easily and then cooled quickly to fit perfectly.

How I Designed This

How I made it...

Created using Freecad 0.21
Made the basic shape, rotated it to make the knob, added a 0.5mm fillet to the front edge, made the finger grips and polar patterned it eight times, made a small (0.5mm deep) cut out as a marker/pointer when in use.