1/2英寸S40标准15mmx15mm正方形管道夹具套装

1/2" S40 to15mmx15mm Sq. Tube Clip Set

2024-03-16 01:06:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

HIDT

From similar project in current workspace.

Designed in FreeCAD GNU LGPL as of 3/15/2024

ASSEMBLY:
1) Print .STL Clip Set
2) Choose appropriate length S40 pipe for project (Recommend 4" to 18" range)
3) Assemble by screwing pipe into clip radial openings
4) Vertical placement of pipes allowing pipe to "slide" on rail for custom placement.
5) Choose appropriate wood slat to go between for shelving and secure with "U" bracket.
6)Assemble piping together for custom shelf.

Print at additional %2 scaling due to cooling effect with PLA filament post printing to ensure piping can perform screw action

HARDWARE
(4x) S40 Pipe (Vertical Support Arm)
(2x) Lateral S40 pipe for shelving support

INFILL: %10

LOAD RATING: Experimental! Currently applied with distributed load at 5lbs/foot. Not to exceed this with %10 infill!!! Print and install at your own discretion as this is a baseline that currently works for a different organizational application and will apply separately per personal use.

ADDITIONAL NOTES:

A)DO NOT Cantilever load as there is no enclosed area to protect major bending moment
https://engineeringstatics.org/distributed-loads.html#:~:text=Distributed%20loads%20are%20forces%20which%20are%20spread%20out,are%20all%20names%20commonly%20used%20for%20distributed%20loads.

Please see Section 7.8.3 from supported text

B)No additional hardware necessary assuming static placement. The 15mmx15mm inset should allow for a tight tolerance and stay in place assuming no major bending moment or lateral forces against assembly with the square tubing