Mitsubishi Montero Pajero 前方上臂撞击缓冲器（低档版） MR113271

Mitsubishi Montero Pajero Low Profile Front Upper Arm Bump Stop MR113271

2024-03-16 02:02:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Mitsubishi Montero Pajero 前方上臂撞击缓冲器（低档版） MR113271

Summary

I see a lot of guys trying to hack up the og bump-stops after cranking the torsion bars, this was my solution to add some padding between the metal mating surfaces while providing maximum downward travel to make up for what was lost.

These should be printed out of TPU95, a rubber like filament that has great layers adhesion and durability to heat, chemicals, and abrasion. The infill and infill design can be adjusted to “tune” its compression rate. I’ve been running them with great success for the past few months so I figured I’d share the info. I will be selling a few sets in my Rogue Montero Etsy shop.

I’m running gen2 UCAs on my gen1, so I can’t 100% confirm gen1 is the same spacing but it looked close from peeking at friends rides.

To attach these to your UCA you will need to but either Ultra-Low-Profile M8-1.25 Socket Head Screws or do what I did, for ease of install I used plastic push rivets, something like 90221A223 from McMaster Car would work or find a simile size at Lowe's or automotive store.

Print Settings

Printer brand:
Bambulabs
Printer:
Bambu X1
Rafts:
No
Supports:
No
Infill:
55% or more
Filament brand:
Bambu Labs
Filament color:
Black
Filament material:
TPU95
Notes:
These are the setting I have been using:
Wall Loops - 6
Top Shell Layers - 6
Bottom Shell Layers - 9
Infill 55%
Infill Pattern - Gyroid

If you have a heavy front end you can increase infill up to 100%.