现代i800（2010）车型杯垫

Cup-holder for Hyundai i800 (2010)

2024-03-17 07:10:43

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This model was designed to provide a replacement for a broken cupholder in a Hyundai i800 (UK 2010).

It requires the original (broken) sliding cupholder assembly to be completely pulled out of its slot. The 3d print can then slide into the available space and provides a permanent dual cupholder for your delectation and convenience (and at your own risk - see licence for details).

Printing and assembly notes

The project was designed for printing on a Creality Ender-3 v3 SE, and is in two parts because the print volume on that printer is not big enough to do it in one go.

I used Cura to slice it (with 15% cubic subdivision fill) and regular PLA to print it. The model is designed to be printed upside down.

You will need 4x M3*16 bolts with associated washers and nuts to attach the two parts using the printed holes. If you don't have these then glue could work I suppose.

In my car the assembly slides in cleanly but firmly, requiring no further fixtures. You will need to check the fit and suitability in your own vehicle. Printing the smaller part 2 first to check for fit would make sense as part of that process.

This is not an official Hyundai part. It has not been safety tested and is not endorsed by any standards body anywhere. Use at your own risk.

Created in Blender using Keep-Making's recommended list of plugins.

The model is licensed under https://creativecommons.org/licenses/by-nc-sa/4.0/