智能辅助吉他拨弦器

Assistive Guitar Pick

2024-03-18 10:31:04

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This guitar pick grip is supposed to assist an individual with holding a guitar pick in the traditional grip (pick in-between thumb and outside of index finger, with remaining fingers curled towards palm), but with some extra support.

You WILL have to drill a 3mm hole through the top of your pick.
You WILL have to print the pick sleeve from TPU.

The red piece, the pick sleeve, was printed from Ninjaflex 85A TPU on a FlashForge Creator Pro. The infill was 20% gyroid with 2 walls. Print this piece standing upwards so there will be no need for supports. The infill and walls dictate how squishy/flexible the sleeve is.

The handle was printed from PLA at 20% grid infill and regular supports on.

You will need a panhead M3x6mm screw and 3mm hex nut. You will thread the screw through the pick and pick sleeve, then tightened with the hex nut on the opposite side. The image above shows where the hex nut goes.