Touptek 2600c 电动 2英寸滤网轮

Touptek 2600c Electric 2" Filter Wheel 5x

2024-03-20 16:54:40

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a 5x electrical filter wheel for the Touptek 2600c (IMX571) color astro camera (also suitable for similar cameras from other brands which share the same form factor).

The wheel and the bottom part needs to be printed at 0.1mm for the thread to work properly.

Requires 1 axial bearing which needs to be put on the bottom part (middle) as well as a 10mm spacer screwed on the top part to have the right backfocus distance for this camera.
A small magnet needs to be glued on the wheel to work as a homing point for the arduino / hall sensor.

For the Arduino SW / HW, see here:
https://github.com/chemistorge/Arduino-Motorised-Filter-Wheel-Xagyl-compatible-ASCOM-and-INDI-

(not my work!)

BOM:

1x 28BYJ-48 stepper motor
1x 5mm round magnet
1x axial bearing (e.g. sourcing map F8-16M 8mm x 16mm x 5mm)
1x Arduino Nano
2 M3 screws for the stepper motor (should be flat head screws, screwed in from the bottom side!)
6x M3*10mm Screws for the connection between top and bottom part
5x M2.5 *8mm screws for the camera to bottom part connection
1x USB cable
10mm spacer (M48)
1x small round magnet for the lid to be glued inside (holds the lid on to the stepper motor case then)