Wolfcraft 工作台夹具适配器

Wolfcraft Work Table Clamp Adapter

2024-03-20 18:47:09

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Two pieces that turn Wolfcraft one-hand clamps into vertical work table clamps for all work tables with 20mm bore holes. So it is not just limited to the Wolfcraft Master 650 table shown in the pictures, nor to specific table thickness.

Usage: push the lower part (wedge) fully through a table hole, then pull down the hat piece until it's fully inside the table hole, then tighten the one-hand clamp as you usually would.

Assembly: orientation matters! Both pieces do have an arrow that should point into the front facing direction of the clamp! I used a M5x10mm hex screw to fix the lower part (wedge) to the clamp. M5x16mm screws should work as well I guess, but haven't tested.

Compatibility: These adapters should fit all smaller Wolfcraft clamps like the EHZ 65-150, EHZ 65-300 and many more that do have the 14x5mm metal rods. It does not fit with the largest Wolfcraft clamps that have 20x6mm metal rods.

Print Settings

Supports:
No
Resolution:
-
Infill:
100%
Filament brand:
-
Filament color:
black
Filament material:
PETG
Notes:
Printed in PETG, 100% solid for stiffness. I printed them without support enabled. Just rotate the objects accordingly and it should print fine.