Bonsai Pot & Hidden Water Tray

2024-03-22 17:48:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A simple Bonsai Pot with a hidden tray that is tucked under the pot.

I printed the pot in the upright position using tree supports. I have seen other bonsai pots and they print them on one side without supports, so I suppose you could try that too.

The pot has holes in the bottom and it has two hooks attached to the bottom, this allows you to attach wire that will help hold the tree in place. I also put a concave in the bottom of the pot to help water flow towards the middle of the tray.

I printed using PLA. If you do the same, I would recommend coating the inside of the pot and the tray with a protective layer to ensure water does not go through. The walls of the pot are 4mm, and if you print with a high infill, you may not see any water issues. The tray has a 2mm wall and while I have not tested water and 2mm, I will protect my tray and space with a sealant just to be sure.