微瑞士 NG 双模 5015 风扇外壳（配备管道内观察镜头附件）

Microswiss NG Dual 5015 blower shroud with Borescope camera attatchment

2024-03-24 01:14:31

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This shroud is identical to the model i released minus the borescope.

I printed these in ABS and Nylon. I would not reccomend PLA or PETG as per the original Microswiss shroud.

For the borescope:

The borescope i used is one of the cheap USB ones you can find on amazon/ebay/aliexpress. The one i chose has white leds in the barrel for lighting when in use. This camera works straight out of the box plug and play on a raspberry pi and crowsnest had no issue displaying the feed.

The camera barrel is 7.3mm and the cable is 3.8mm diameter.

You will need 2 M3 threaded inserts (see pic for which type) and 2 M3x10 Button head cap screws for the borescope clamp. Take care to order the correct type of threaded inserts for this as its important they are correct due to the hole size. You could also glue this in place but you will be permanently affixing the borescope to the shroud by doing so. Completely up to you.

For the fans as per the original model you will need 4 M4x20mm button head screws and 4 M4 nuts to secure the fans to their mounts.

Also required is a M3 10mm button head screw and nut for the right side screw mount to the backplate. Screw it on from the opposite side of the backplate, mount the shroud and use a M3 nut to secure the right side of the shroud. (see pic).

The left side screw goes in as per the original shroud into the backplate.

I printed the version i am using now using .2mm layer height and 40% gyroid infill, but when i was running test prints during the iteration process of designing this .32 layer height and 25% infill came out just fine. Important that the clamp is printed at .2mm layer height, it loses too much detail at .32 and above.

Might pay to print this a bit slower than normal, you know your printer better than me, but i got best results when slowing it down.

微瑞士 NG 双模 5015 风扇外壳（配备管道内观察镜头附件）

朋友，你觉得上面这个模型，属于下面的哪个分类？