Totoro自水植物盆（remix版）

Totoro Self Watering pot (remix)

2024-03-24 04:19:31

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I liked the original design a lot, but it's barely printable, if at all, even before scaling down - and scaled down to 50-60% it's non-printable, because the wall width there is miscalculated in the thin part and becomes a hole. After fixing that, the bottom was overhanging too much and causing Cura to output fully filled layers, and the incrustations on the chest were starting to print on nothingness. So I've decided to fix all that and make it printable down to 50-60% scaling, and in addition modified the insert to print upside down without the need for support, and even put an anti-mosquito net in the water pipe. The net doesn't really come out straight at 60% scaling, but it's dense enough to do its job.

Since I did all that, I figured I'd just as well share it, maybe other people like Totoro like my wife does. So here it is. I printed at 60% scaling and never tried printing it full size, but I believe it should work.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
No
Supports:
No
Resolution:
Standard 0.2
Infill:
10%
Filament brand:
eSUN
Filament color:
Rainbow
Filament material:
PLA+
Notes:
I've printed at 80mm/s and it came out very pretty and tolerated the overhangs without support. Could probably run faster on a well-calibrated bedslinger with movement sensor / CoreXY, and maybe even 120 mm/s could haved worked on my setup, but I wasn't in a hurry and preferred getting good results first shot.