LD2410C与D1小型版

LD2410C + D1 Mini

2024-03-24 15:15:37

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This a remix of PhantomGear's design to hold a D1 Mini ESP8266. The mount for the D1 Mini came from here: https://www.thingiverse.com/thing:4757811. I have also added vent holes to the rear case.

On my first attempt to de-solder the header pins from a LD2410C I knocked of a surface mount resistor. So I modified the mount plate so the pins can pass through and be bent up. Once you have the pins bent in the correct place (about half height) you can just solder on wires and cover with heat shrink. The LD2410C can then be slide in front the side of the plate. I held the LD2410C in place with a couple of small pieces of electrical tape.

I found the LD2410C gets quite warm so I modified the front plate to be vented.

I also made some 1 mm spaces to go between the mounts on the arm as I found even with the screws tight I could not get it to grip.