可折叠骰子塔
Collapsible Dice Tower
使用说明
- 所有模型资源均由用户上传分享，内容来源于网络公开资源
- 侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
- 模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力
关于费用
我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！
扫码手机访问
抖音私信 @jobsfan
Summary
I wanted to create a collapsible dice tower I could take to Dungeons and Dragons. The upper tower has a Spiral, Then the dice drops into a lower section where it fall out. The print uses around 200 grams of filament depending on infill density, support type, and orientation of the print.
Print Settings
- Printer brand:
LulzBot
- Printer:
Mini 2
- Rafts:Doesn't Matter
- Supports:Yes
- Resolution:any
- Infill:20%
- Filament brand:
I used PolyLite
- Filament color:
I recommend gray
- Filament material:
PLA
- Notes:
I suggest messing around with the support settings because the supports may generate between each layer of bricks as it did for me. If it does this I used an exacto knife to remove the supports between the bricks.
Post-Printing
Assembly
The assembly is in two parts. First take the two upper tower halves and glue them together using superglue. Than take the complete upper tower and put it inside the two halves of the bottom tower gluing it together with the upper tower inside. Make sure not to glue the two pieces together.
相关内容
猜你喜欢
联系我们
最新模型
-
FCX18 1/18比例 RC爬行器 & 无线电站2024-05-08 -
3D模型标题：吊坠 2.75厘米2024-05-08 -
显卡支持2024-05-08 -
无线蓝牙音频播放器2024-05-06 -
DJI动作4防震支架艾沃克 F5/F62024-05-06
最热下载
-
Gyro Air旋转空气模型2023-03-26 -
沃帕尔六足行走机器人2023-03-26 -
线框无心2024-05-08 -
厨房水槽滤网过滤器2025-06-05
