特鲁茨越野骑士跑车前方护板 & 后方护板架架

Trout's Off-Road Knight Runner/Front Runner Rear Bumper & Bumper Rack

2024-03-28 05:45:15

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This rear bumper is NOT finished, YOU need to drill holes where you want them on the bumper's mounts. This bumper is made for the Enduro Knight Runner/Front Runner 1/10 scale RC truck. The bumper rack slides into the hole in the center of the back bumper, then use the pin in the opposite direction the mount of the rack is going.

Pin instructions: 1st glue the circle ring or stopper at the end of the pin which is the straight cylinder. 2nd Drill a hole close to the edge of the cylinder's side without the stopper, but not too close or it will be fragile, still being enough for a pin to stop it at the end. 3rd Find a clip to stop the pin from moving side to side.