自动种子发芽器 - 自水功能

Automiatic Seed Starter - Self Watering

2024-03-28 18:14:05

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Springtime, finally. Plenty of seeds that need some kind of special attention (some extra warmth, extra humidity...). Following up on my earlier simple seed starter (of which we use dozens in our small green house), here is s fully automatic (well kind of...), self-watering seed starter, mainly intended for in house (window sill, green house...) use.

It uses the same 2x2 simple seed starter from my earlier post but with an added tray, lid, and floater. Once the seedlings have started growing (and don't need special attention), you can simply remove them from the tray and put them in a green house. We are using these mostly for peppers and other seeds that need more warmth and/or humidity than they would otherwise geed in our green house (i.e. we simply put them on our heater).

PRINTING. This should be a pretty simple print. Ideally set line width to 0.5 mm (walls are 1 and 1.5 mm). Preferably use low vertical resolution for faster print. Print the lid in your favorite transparent filament and print upside down. Infill does not matter. No supports needed. I use some cheap epoxy resin for sealing my prints (i.e. making them waterproof, in this case I used it for the trays only).

FILAMENT. Use PLA for biocompatible kits or PETG if you want them to withstand higher temperatures. I use some cheap and easy to print CF PLA for the seed starters and trays, transparent for the lids.

Happy printing!

PS.: This post may contain affiliate links and I may I get commissions for purchases made through links. You can support me by simply ordering through these links (and it won't cost you any extra).