Fleshlight 飞行器末端盖

Fleshlight Flight/Pilot/Go Flat End Cap w/ Grip

2024-04-01 06:18:34

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The cap to my Fleshlight "Flight" cracked so I needed to make a replacement part. LuckilyThingiverse user @Nosse666 posted a cap for their pilot model, and because the "Flight" and "Pilot" have the same case I didn't have to go through the process of modeling the threads.

I added some voids in the threads similar to the original cap to reduce friction.

I added a couple of millimeters to the walls of the cap above the threads to cover the vent holes and control suction more easily. This also made it much easier to screw on the cap completely without becoming too tight to remove. I also added a 2mm chamfer to the inner edge, because there is a small protrusion at the bottom of the threads on the case. That also made it difficult to fully tighten and remove the cap printed from the design I modified.

Last I added some gear-like protrusions to make it even easier to screw on and off, as I always had difficulties with the smooth sides of the original endcap, especially when my hands were slippery.

I read somewhere the "Fleshlight Go" series cases use the same sized threads as the "Flight" series so, this cap may fit on those other models as well. Lmk if anyone can confirm this.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra 2
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
50
Filament brand:
Anycubic
Filament color:
Black
Filament material:
PLA
Notes:
Uses Prusa slicer with 5 solid layers on top and bottom, adaptive cubic infill, and 3 primer loops.